Info

The hedgehog was engaged in a fight with

Read More
Q&A

Why is my dryer light not working?

Why is my dryer light not working?

Unplug the power cord and remove the light bulb. Reach into the light socket and bend the center contact out just a little and then reinstall the light bulb. Plug the dryer in and see if the light comes on when you open the door. If the light does not come on, the door switch is likely faulty.

What to do if your electric dryer wont start?

On most dryers the drive motor turns the drum and the blower wheel to exhaust the air. If the dryer won’t start the motor might be defective. Before replacing the motor, check the thermal fuse, start switch and door switch because all three are more likely the cause.

Where is the start switch on a dryer?

The start switch is on the dryer control panel. Depending on the model, either press a button or turn a dial to start the dryer. If the start switch fails the dryer won’t start or make any noise. Test the switch with an ohm meter or continuity checker.

What kind of dryer is Kenmore Elite He3?

The Kenmore Elite HE3 is 7.2 cu. ft. capacity electric dryer by Kenmore. Dryer won’t start (interior light working, control panel not working)? My gas dryer is 10 years old, purchased in 2004. Last week it stopped working. The interior light turns on when I open the door, and it turns off when I close the door.

When to replace the timer on a dryer?

Replace the timer if the contacts aren’t working, the dryer won’t start, heat or continue running, or the timer won’t advance. If your dryer won’t advance through the drying cycle, the timer might have failed. This step-by-step repair guide and video show how to replace a dryer timer in 30 minutes or less.

How do you repair a Kenmore dryer?

How to Fix a Kenmore 90 Series Gas Dryer That Will Not Heat Step 1: Unplug the dryer from the wall and turn off the gas!! Step 2: Release the two top spring clips from the lower front panel. Step 3: Lift the door up and off the two springs that slide into slots in the bottom of the door. Step 4: Locate the igniter.

Do Kenmore clothes dryers have a reset button?

Your Kenmore dryer does not have a reset button. If the dryer is not starting; located the two house circuit breakers dedicated for the dryer and reset the two breakers and then see if will run.

Where is the reset button on my Kenmore dryer?

To reset the washer you have to Press and hold the END OF CYCLE/CYCLE SIGNAL button for 20 seconds. This button is usually located on the right side of the panel facing the front of the washer. Similarly, if it is a Kenmore Washer you can press and hold the DRAIN/SPIN button for 20 seconds.