Info

The hedgehog was engaged in a fight with

Read More
Q&A

What causes water to leak from under the washing machine?

What causes water to leak from under the washing machine?

Leaks under the washer are commonly caused by a damaged water pump or compromised hoses connected to the pump. Usually, you will notice lots of rumbling or shaking from the machine during a wash cycle if the pump is faulty. The water pump in a washer is generally located at the bottom of the machine.

What causes water to leak from a Kenmore washer?

Be aware that this is a complicated repair and will require disassembling most of the washer. The tub seal might be torn, causing water to leak from the seal. If the tub seal is leaking water, water may leak through the tub seal and into the tub bearings. This can cause the bearings to fail.

What to do if your Kenmore washer is filling slow?

If Kenmore Washer Is Filling Slow, Check: Water Inlet Valve. This valve opens during the wash cycle to allow water to fill the machine. If this valve is faulty, the water may fill slow, or not at all. Also keep in mind that this valve requires good water pressure to work right. So, first check that your water pressure is adequate.

What should I do if I find damage to my Kenmore washer?

If you find damage replace the hose. Some Kenmore washers feature coin traps to catch small objects before they reach the pump. This part needs to be clean and free of debris to ensure your washer is draining correctly. Simply remove the trap and thoroughly clean it. Eventually the shocks in your washer can wear out.

Where is the drain pump on a Kenmore washer?

Based on you details the drain pump is likely leaking water. The drain pump is located directly in the front center area of the washer. In order to access and replace the drain pump will require removing the washer cabinet.

What to do if your Kenmore washer is leaking?

Take your old hoses to the hardware store so you get the right replacement parts. If the supply hoses are fine but the washer still leaks while filling, then check the internal hoses for any leaks. You may have to unscrew the rear panel to look at the insides of the washer.

What causes a Kenmore washing machine to overflow?

The water inlet valve requires a minimum of 20 psi to shut off properly. If the water inlet valve does not get enough pressure, the valve may not close fully after the power is shut off. As a result, water can leak into the washer and cause it to overflow. Check the water pressure to determine if it is sufficient.

Where does the water come from in a Kenmore washing machine?

The Kenmore 110 Series is an easy to use home Washing machine created by Kenmore. There is a lot of water on the floor during my wash then drain cycle? It doesn’t seem to be coming from the back but underneath maybe?

Why does my Kenmore top load washer not spin?

Lid Switch (top load machine) Your Kenmore washer will not spin if the lid switch is faulty. This is a safety feature, to prevent accidents when somebody wants to stick his hand while washer is spinning. To check this you’ll use a multimeter to check for continuity in the switch. If there is none, replace the switch.