The hedgehog was engaged in a fight with

Read More

What causes a boiler to flood?

What causes a boiler to flood?

Dirty water, a too-high pH, overfiring and improper near-boiler piping can all cause the boiler’s water line to surge up and down. Even a tiny pinhole in a tankless coil will flood a boiler because the pressure inside the coil is so much greater than the pressure in the boiler.

How do you fix a flooded boiler?

Boiler in a flooded basement:

  1. Replace all controls, gas valves, and electrical wiring on the boiler.
  2. Thoroughly inspect all burner tubes, gas piping, manifolds, orifices, and flue ways for signs of rust and/or sediment from the flood waters.
  3. For oil-fired boilers, replace all oil burners.

What causes surging in steam boiler?

Surging begins when dirt and oil accumulate on the boiler water’s surface. As the steam tries to break free, it lifts the water, creating the surge. You can see this in the gauge glass. Since steam systems are open to the atmosphere, you occasionally need to clean them.

Why high water level is not good for boilers?

The dangers of an excessively high water level in a steam boiler include: Increased carryover of water into the steam will result in poor operation and/or malfunction of the steam system components, due to dirt. Wet and dirty steam can contaminate or spoil the product where it is used directly. Poor product quality.

Why is my Weil McLain boiler not working?

1. No Heat At All A burned-out thermocouple is the top cause of a Weil McLain boiler not responding to the thermostat’s call for heat. 2. Little or No Heat Insufficient water pressure will prevent the boiler from creating enough hot water to adequately heat your home.

What kind of company is Weil McLain heating?

Originally, it was a small plumbing and heating house. Now the company is a leading developer and manufacturer of heating systems. The company sees its mission in the design and manufacture of comfortable equipment and maintaining a leading position in the market.

Where to find thermostat on Weil McLain boiler?

Locate thermostat on inner wall away from heat sources or cool drafts. Adjust thermostat per manufacturer’s instructions. Set limit according to system needs. Maximum setting is 220* F. Increase limit setting to decrease cycling. Check all valves to and from boiler. Return to proper setting. Confirm circulator size.

Why is water leaking from the boiler relief valve?

A common sight in a hydronic boiler room is water dripping from the discharge pipe of the boiler relief valve. While it may appear to be inconsequential, it could cause extensive damage to the heating system. Some boiler rooms have a bucket under the relief valve discharge pipe to mask the problem.