Info

The hedgehog was engaged in a fight with

Read More
Guidelines

How do I get the lid off my top load washer?

How do I get the lid off my top load washer?

You’ll need to unhook the long bundle of cables from where it leads inside the washer console.

  1. Close the Top Panel.
  2. Step Behind the Washer.
  3. Remove the Console Back Panel Screws.
  4. Release the Clips with a Putty Knife.
  5. Tip the Console Forward.
  6. Release the Wire Harness.
  7. Thread Out the Old Lock Assembly.
  8. Open the Washer Lid.

Can you remove a washing machine lid?

Open the lid on the washing machine and place your hand between the drum and the top of the machine. Lift upward and toward you to remove the metal cabinet. If the cabinet does not lift easily, slide it toward the front of the machine, then lift. Be careful not to dent the casing as you take it away from the drum.

How do I turn off the lid lock on my Kenmore washer?

Turn off the washer and unplug the appliance. Locate the retaining tabs and/or screws that hold the top horizontal panel down. Look for the lid lock switch on the underside of the top panel and where it fits into the appliance. Put the lid back down and plug the washing machine back into the electrical outlet.

How do you remove the lid from a top load washer?

In the hole in the side of the washer cabinet, thread out the trailing wires to remove the lid switch wires from the washer console. Now remove the tape from the washer lid and open it the traditional way.

Why is the lid on my Kenmore washer not working?

This article has been viewed 25,703 times. Learn more… If your Kenmore washer won’t spin after filling up the basket with water and agitating your clothing, then your lid switch may be bad. Maybe, it’s something else. Either way, you need to get that control panel up off of the washer. Here is how.

Can you replace the lid on a Kenmore Centennial washer?

Specifically, the Kenmore 110 washers, Maytag Centennials, and Maytag Cabrio washers. Join us in removing your old lid switch before reversing the process to reinstall a new washer lid switch. The first step for any repair is to gather your supplies.

Can you remove the cabinet on a whirlpool Roper washer?

This video shows you how to remove the cabinet on a Whirlpool, Kenmore or Roper washer. From here you can access the motor, drain pump and the lid switch along with many other parts. This is usually the first step you need to take when it comes to repairing your washer.

This article has been viewed 25,703 times. Learn more… If your Kenmore washer won’t spin after filling up the basket with water and agitating your clothing, then your lid switch may be bad. Maybe, it’s something else. Either way, you need to get that control panel up off of the washer. Here is how.

How to replace the lid on a top load washer?

Push back on the control panel while sliding a putty knife under the right corner of the control panel to release the mounting clip. Repeat on the left side to release the console. Lay the console on the top of the washer.

How do you remove the top of a Sears washer?

Steps Be sure you have the replacement part that you need to remove the top for. Be sure to unplug the washer and disconnect the water hoses. Look at the back of the washer for the screws that you will need to remove. Remove the screws that connect the assembly to the washer. Remove the end caps of the control panel.

How do I remove the lid lock assembly?

Using a 1/4-inch nut driver, remove the 2 mounting screws that secure the lid switch/lock assembly to the top panel. Release the lid switch/lock assembly from the top panel. The lid switch/lock assembly is still attached to the wire harness. Let it hang from the wire harness for now.